Reassemble | search
Click here to view Reassemble news from 60+ newspapers.
Bookmark or Share- LCP slide won't reassemble - Ruger ForumThe hammer was proabley up in the fired position when you tried to install the slide. The hammer must be down when you install the slide. About to problem with the barrel rubbing aganist the slide. Check under the slide and look at the top front of the ejection port and make sure there are no little bumps there.
- Problem Reassembling .22LR MarkIII - Ruger ForumProblem Reassembling .22LR MarkIII. I can't get my Mark III back together. I know they are "tight" until you have taken them apart and put them back together a few times, but it is not supposed to be impossible. I am up to the point where you insert the bolt stop pin, and then swing the mainspring housing assembly back into the back of the handle.
- Need an extra hand to reassemble the SR1911? - Ruger ForumThis will allow the spring cap to be released so you can ease the cap and recoil spring out. Once tension has been relieved, place the thumb safety in the FIRE position then move the slide back until the take down notch aligns with the slide lock. Push the slide lock out from the right side of the slide and remove it.
- Uh oh, how to reassemble Ruger Standard? - Ruger ForumHLG, FWIW (on reassembly), after I get the upper in place and insert the bolt, I aim the muzzle down and briefly pull the trigger, allowing the hammer to fall into its fired position. From that point, I hold the gun normally and install the mainspring assembly in place, but leave 1\4" of the lock-down arm out.
- The Mark II Re Assembly - Ruger ForumSet Hammer in the Un-cocked "vertical" position (point muzzle down, pull trigger) 5. Install Main Spring's Stop Pin through holes in receiver and bolt..verify stop pin protrudes 1\8" beyond top of receiver Then, point muzzle UP just 45 degrees and swing the Main Spring body into grip frame's recess.
More
