Fabrication | search
Click here to view Fabrication news from 60+ newspapers.
Bookmark or Share- The ULTIMATE Welding Cart: Design | Cut | Build S2:E5The result included not only our POWER MIG® 210MP welder, but also the SQUARE WAVE® TIG 200 and the FLEXCUT® 80 plasma cutter. So now it spans a little broader than your typical welding cart, making it the ultimate fabrication cart.
- FabricationForum.comA forum to discuss everything related to welding, fabricating and CNC cutting.
- torchmate 4X4 jogging issue - FabricationForum.comsorry about that i ment to say hi speed ,no luck with the cables ,i disconnected the gantry from the stepper motor in the x axis and it slides free from end to end but it only hits the hard stops evenly on one end of the table ,the other end is off approximately 1/4 .and i also need to adjust the side to side position of the gantry ,it's loose on one side and snug on the other
- Torchmate® Tips and Tricks | FabricationForum.comThe rip cut is very handy I use it all the time your video was very useful. I was trying to rip cut basically square out of a piece of steel but retaining the factory edge on the one Y and X axes .
- best chemical for plasma table? | FabricationForum.comWe use a water/sodium nitrite solution in ours and green food coloring with zero problems so far. Have to top the water table off periodically but this mix works great for us.
More
